AWS CWI, HULL, WELDING, Welding Engineer, Welding InspectorLeave a comment

What is Chill Plate in Welding

December 19, 2020 Amarine Antonio

In general, butt joint welding is divided into two-sided welding welded on both sides and the back gouging must be applied due to poor welding quality at the first welding layer of the first one-sided welding. (Call completed joint penetration, See What is CJP in welding) For one-side welding method, a backing material, which is a backing material that prevents melting of molten metal, is attached to the backside of the base material, and then the welding wire is lowered to form an arc between the base material to weld the base material. Welded Chill Plate (or Permanent backing strip, … Continue reading What is Chill Plate in Welding

HULL, SHIP SURVEY

Protected: HULL SURVEY – PRINCIPAL DIMENSIONS AND DISTORTION

November 20, 2017December 23, 2019 Amarine Antonio

There is no excerpt because this is a protected post. Continue reading Protected: HULL SURVEY – PRINCIPAL DIMENSIONS AND DISTORTION

CHEMICAL TANKER, HULL, SHIP SURVEY

Protected: HULL SURVEY – HYDROSTATIC AND WATERTIGHT TEST (Erection, fillet air test, chalk test, strength test of tanks, compartments)

October 23, 2017November 14, 2019 Amarine Antonio

There is no excerpt because this is a protected post. Continue reading Protected: HULL SURVEY – HYDROSTATIC AND WATERTIGHT TEST (Erection, fillet air test, chalk test, strength test of tanks, compartments)

CHEMICAL TANKER, HULL, SHIP SURVEY, WELDING

Protected: HULL SURVEY – FINAL INSPECTION

October 17, 2017December 23, 2019 Amarine Antonio

There is no excerpt because this is a protected post. Continue reading Protected: HULL SURVEY – FINAL INSPECTION

BASIC THEORIES, HULL, SHIP SURVEY5 Comments

COFFERDAM VS VOID SPACE

October 16, 2017December 26, 2019 Amarine Antonio

Visit: Shipbuilding Knowledge A-Z for more free topics on shipbuilding Check the passwords and visit: Protected: COFFERDAM VS VOID SPACE (full words) Continue reading COFFERDAM VS VOID SPACE

HULL, WELDING

Protected: HULL SURVEY – BLOCK ERECTION (full words guideline)

October 16, 2017November 16, 2019 Amarine Antonio

There is no excerpt because this is a protected post. Continue reading Protected: HULL SURVEY – BLOCK ERECTION (full words guideline)

HULL, SHIP SURVEY, WELDING

Protected: HULL SURVEY: BLOCK INSPECTION

October 11, 2017November 14, 2019 Amarine Antonio

There is no excerpt because this is a protected post. Continue reading Protected: HULL SURVEY: BLOCK INSPECTION

HULL, SHIP SURVEY3 Comments

HULL SURVEY: FABRICATION & ASSEMBLY PROCEDURE

October 11, 2017October 13, 2017 Amarine Antonio

General Defects in construction usually cannot be detected after the fabrication and welding work has been finished. During in shop fabrication the precise accuracy of this process will govern the final accuracy of the assembly unit. The surveyor should engage in frequent patrol inspections, taking every possible opportunity available on the way to or from the block yard to carry out block inspections or from building berth for tightness tests etc. He has to pass the fabrication shops to see the prefabrication process such as surface treatment, marking, gas cutting, bending, bracket profile, build-up section, tack welding etc. When defects … Continue reading HULL SURVEY: FABRICATION & ASSEMBLY PROCEDURE

HULL, SHIP SURVEY