Category: API Inspector

API 510, API Inspector, OIL & GAS, PIPING2 Comments

Test Pressure vs MAWP (ASME VIII)

Amarine Antonio

Hydrostatic Test Pressure vs MAWP of Section VIII Vessels;  An example of Hydrostatic Test Pressure compared to the MAWP of Pressure Vessel ( in the form of Shell & Tube Heat Exchanger) designed according to ASME Section VIII Div.1. What is Hydrostatic Test Pressure for Section VIII Vessels; The Hydrostatic Test of Pressure Vessel according to the ASME Section VIII Div.1 must be done at a pressure not less than 1.3 times of the Maximum Allowable Working Pressure (MAWP) of the Vessel multiplied by the Stress Ratio to compensate for the strength of the material. In case of use at high temperatures ( when Hydrotest is made at Ambient Temp.) , The Stress Ratio is the ratio of the Allowable Stress of the material to … Continue reading Test Pressure vs MAWP (ASME VIII)

API 510, API Inspector, OIL & GAS, PIPING, PRV PSVLeave a comment

What is PRV valve Trevitest ?

Amarine Antonio

PRV Testing – Trevitest (Principle);  Trevitest Test Set Pressure of the Pressure Relief Valve (PRV) with On-Line while PRV are In-Service without adding (Build up) the pressure in the whole system approaching the Set Pressure. The Trevitest test kit uses the Hydraulic Lift Assist Device to help push the spindle of the PRV to overcome the spring force without increasing the pressure in the system and calculate the set pressure of the PRV using the pressure in the system. PRV Testing – Trevitest (Tools Setup); Examples of tools and installation of Trevitest test  kits installed on the Pressure Relief Valve at the site:   PRV Testing – Trevitest (Result Interpretation);  Interpretation of Trevitest  test results is done by using the software that comes with … Continue reading What is PRV valve Trevitest ?

API 510, API Inspector, OIL & GAS, PIPING, PRV PSVLeave a comment

What is PRV Field Test?

Amarine Antonio

PRV Testing – Field Test; Test Set Pressure and Seat Tightness Test of Pressure Relief Valve (PRV) at the venue (Field Test) can be performed using a kit for compressed inward, Inlet performed on Nozzle of PRV, which will make the case that PRV is large, located on a high ground, difficult to transport. Refer to: What is PRV pop test? (Popping test) Continue reading What is PRV Field Test?